3-parts kit from fine 3D printed Resin for the representation/realization of a trailer bumper with two separate rear lights units for ITALERI trailer in the scale 1:24. In addition to the bumper with the measurements 97mm wide, 17mm high, 5mm deep, two separate light units are included to complete this trailer bumper. Due to the mounting points on the back, this bumper can be easily exchanged with the ITALERI kit part. In addition, there is a strip on the underside of this bumper to easily mount the AKM trailer mudflaps (which you can also find in my shop). NOTE: For reasons of stability or as transport protection, the item is delivered with the proofs from the 3D print (see photo!) and you still have to clean it up!!! Do not remove these proofs with your hands, but with appropriate tools (sprue cutters). Parts can break if handled improperly! Protect unpainted parts from direct sunlight !!!